User Manual

7.2 Display
 Charge/Discharge current: Shows the present charge/discharge current setting.
 Elapsed Time*: The charging/discharging time of the last cycle is displayed.
 Accumulated capacity: The accumulated battery capacity is displayed in mAh.
 Charge voltage: The instantaneous battery voltage is displayed.
 Internal Resistance (IR) **: The current cell internal resistance (impedance) is
display
ed
 Full: After a battery has been fully charged, the status icon would read "Full", and
the charger will switch to trickle charging. Trickle charging is a very small
charging current that compensates for self-discharging of your fully charged
batteries, without the risk of overheating or overcharging.
*Once the the elapsed time has reached 19 hours and 59 minutes, the timer will reset
and begin counting from 0:00 again.
**The internal resistance reading provided by this charger is only for reference, e.g. when
comparing the IR between two cells. When an accurate IR reading is needed, an
industrial grade measuring equipment will be required..
8. Maintenance.
The device is maintenance-free but should be cleaned occasionally. When cleaning, the
device must be removed from any power source. Only use dry and soft cloth to clear
housing of the charger. Do not u
se abrasive or solvents.
9. Dispose of electrical and electronic waste properly in order to preserve, protect
and improve the quality of environment, and protect human. Please return unserviceable
product to relevant facilities in accordance with statutory regulations.
Warning
 This battery charger can only charge NiMH/Cd batteries.
 Please read the specifications carefully before use, and pay close attention
to
the recommended charging current. Do not select charging current higher
than the recommended settings.
 Please don`t use this charger with other power adapters.
 The charger's temperature may increase significantly during operation. Please
8