Use and Care Manual

265559
TRFA01-XL OPERATION MANUAL
NOT FOR DRINKING WATER
B A T T E R Y O P E R A T E D F U E L T R A N S F E R P U M P
SAFETY INSTRUCTIONS
WARNING : IMPROPER USE CAN CAUSE A DEATH OR SERIOUS INJURY
WARNING
: IF THE EQUIPMENT IS USED IN A MANNER NOT SPECIFIED BY THE MANUFACTURER ,
A FIRE HAZARD MAY BE CAUSED
Do not transfer fuel while vehicle or the vehicle’s heater is ON (may cause a fire).
Do not leave the pump unattended (may cause oversupply of oil, a fire or any accident).
Do not alter or disassemble the pump (may cause failure of the product or an accident).
Do not place the pump in a wet area (may cause failure of the product or an accident).
Make sure to use the pump on even surface
(If the tank falls down during the liquid supply, liquid will leak and may cause a fire or an accident)
Do not use deteriorated or aged fuels (these may cause our product to fail).
Do not use for drinkable liquids, or with thinners, solvents, hot liquid, Aceton, Benzen,
Creosol, Ethyl, Phenol, Methyl ethyl, concentrated caustic soda liquid, Nitric acid,
Hydrochloric acid, Sulfuric acid, etc.
Do not shock the pump (may cause a failure or damage of the product).
Do not put the product in a vehicle with all windows closed, direct sunlight area, or next to any
heating appliances (may cause an accident or transform the product).
Do not run the pump ‘dry’ or let the pump idle without transferring (may cause failure of product).
Do not close the hole of sensor inlet. Do not supply the oil into transparent vessel under direct
sunlight (may not stop automatically and overflow of liquid).
Do not allow children to operate the product without adult supervision.
Do not use the product on carpet, wood floor or combustible area (may cause a fire). Be careful
not to damage the floor surface and/or carpet by fuel leakage.
Make sure the pump is tightly secured to the tank before turning the pump on.
Make sure the sensor on the discharge nozzle is vertical (may not stop automatically, could cause
fuel to overflow).
Make sure to press the OFF switch after each use of the pump (may cause the continual
consumption of battery and leak of liquid which will cause malfunction of the product).
Make sure remove any left-over fuel in the pump after each use (may cause of failure of the
pump if fuel remains around the sensor).
Make sure to detach the tank from the pump when moving and when storing the tank (may cause
leak of fuel if moved while the tank is attached).
Adjust the discharge nozzle up so that the sensor is closer to
the top of the supply tank
Our company shall not take any responsibility for any failure of product, malfunction and damages caused by improper use by user or third parties.
C AUSE OF F AILURE AND T REATMENT
SYMPTOM
CAUSE
TREATMENT
Pump does not operate even after
pressing ON
Pumps performance is low
Pump starts after pressing ON button but
then stops unexpectedly
Motor stops before receptacle tank is full
Pump immediately stops after pressing the
ON button
Batteries may be incorrectly placed
Batteries are depleted
Batteries are depleted
Batteries are depleted
Batteries are depleted
Elevation of receiving tank is higher than supplying
tank
Filter of receiving tank may be blocked with
foreign material
Sensor is too low and is touching the liquid
Ensure the batteries are placed in the pump correctly
Replace the batteries
Replace the batteries
Replace the batteries
Make sure that the receiving tank is not elevated
above the supply tank
Clean foreign material from the filter
Replace the batteries
1941 E OCCIDENTAL ST
SANTA ANA, CA 92705
[e-mail]
terapump.net
1-877-251-2288
DO NOT DO THIS
YOU MUST DO THIS
V4 08/10/2016