Specifications

Cinterion
®
ALAS66A Hardware Interface Overview
5.4 Compliance with FCC and ISED Rules and Regulations
43
 ALAS66A_HIO_v01.000a 2019-02-26
Confidential / Released
Page 41 of 51
5.4 Compliance with FCC and ISED Rules and Regulations
The Equipment Authorization Certification for the Gemalto M2M modules reference application
described in Section 5.3 will be registered under the following identifiers:
•ALAS66A-W:
FCC Identifier QIPALAS66A-W
Granted to Gemalto
M2M GmbH
•A
LAS66A-US:
FCC Identifier QIPALAS66A-US
ISED Certification Number: 7830A-ALAS66AUS
Granted to Gemalto
M2M GmbH
Manufacturers of
mobile or fixed devices incorporating ALAS66A-W modules are authorized to
use the FCC Grants and ISED Certificates of the ALAS66A-W modules for their own final prod-
ucts according to the conditions referenced in these documents. In this case, the FCC label of
the module shall be visible from the outside, or the host device shall bear a second label stating
"Contains FCC ID: QIPALAS66A-W"or "Contains FCC ID: QIPALAS66A-US", and accordingly
“Contains IC: 7830A-ALAS66AUS“. The integration is limited to fixed or mobile categorized
host devices, where a separation distance between the antenna and any person of min. 20cm
can be assured during normal operating conditions.
For mobile and fixed operation configurations the antenna gain, including cable loss, must not
exceed the limits listed in the following Table 11 and Table 12 for FCC and/or ISED.
Table 11: Antenna gain limits for FCC for ALAS66A-W
Maximum gain in operating band FCC limit Unit
850MHz (GSM) 2.5 dBi
1900MHZ (GSM) 8.0 dBi
Band V (UMTS) 8.5 dBi
Band 5 (LTE-FDD) 9.4 dBi
Band 7 (LTE-FDD) 12.0 dBi
Band 26 (LTE-FDD) 9.8 dBi
Table 12: Antenna gain limits for FCC and ISED for ALAS66A-US
Maximum gain in operating band FCC limit ISED limit Unit
850MHz (GSM) 3.4 0.1 dBi
1900MHZ (GSM)
2.0 2.0
dBi
Band II (UMTS)
7.5
7.5 dBi
Band IV (UMTS)
4.7 4.7
dBi
Band V (UMTS) 8.4 5.1 dBi
Band 2 (LTE-FDD)
9.1 8.5 dBi
Band 4 (LTE-FDD)
6.5 6.5
dBi
Band 5 (LTE-FDD) 9.4 6.1 dBi