Installation & Assembly

ManualsBrandsThe Renovators Supply Inc. ManualsBathroom Remodel & Bathroom Fixtures1.6 GPF Round Wall Hung Toilet (Seat Not Included)

Please Read The Following Instructions Before Installing:

Classic Z-pipe High Tank Toilet

Preparation and disassembly

Toilet Bowl Installation

1.Shut off water supply to the existing water closet

2.Disconnect water supply tubing from existing tank and angle

stop valve

3.Remove existing water closet and tank from floor

4.Remove old wax seal and clean area around the drain

5.Draw a center line(as illustered)through center of the drain to

the wall. Plumb a line vertically to the wall up to 79", at this

point draw a horizontal line on either side of the center line.

1.To install the toilet bowl turn it upside-down.

Place the new wax ring (available at any hardware or

plumbing supply store) and sleeve over the drain horn.

Press it down firmly. Note: if the ring has a paper cover,

remove it.

2.Make sure the toilet flange is clean and the floor bolts

point straight up. Carefully position the toilet bowl over the

flange, and fit the holes in the toilet base dircetly over the

floor bolts.

3.Press down on the toilet bowl to compress the wax ring,

to form a tight seal. Attach the washers and nuts to the

floor bolts, and tighten them with an (non-scratch) adjust-

able wrench. (Note: Don't over-tighten the bolts as you

may crack the ceramic base).

Toilet Bolt Covers are available at rensup.com

17612 White, 17613 Bone, 17614 Black

These instructions and drawings disclose confidential and other data of proprietary

nature owned by Renovator's Supply, Inc. and may not be used or disclosed to

others without the prior consent of Renovator's Supply, Inc.

ZpipeRev052010

Summary of content (4 pages)

PAGE 1
Please Read The Following Instructions Before Installing: Classic Z-pipe High Tank Toilet Preparation and disassembly 1.Shut off water supply to the existing water closet 2.Disconnect water supply tubing from existing tank and angle stop valve 3.Remove existing water closet and tank from floor 4.Remove old wax seal and clean area around the drain 5.Draw a center line(as illustered)through center of the drain to the wall.
PAGE 2
Flush Arm Fill Valve Flush Valve Small Plastic Locknut (for Fill Valve) Large Plastic Locknut (For Flush valve) Rubber Fill Tube PlasticTank Liner Wood Tank Hanger Bracket Pull Chain Moulding Bracket Conversion Panel Cover Plate 47" Stainless Steel Tube Medium Decorative Nut Large Decorative Nut Rubber Washer 1/2" Water Supply Line Compression Coupling Shut Off Valve 12" Supply Line Nipple Flange Eye Screw Bracket Screw (Plated) Moulding Bracket Screw S/S Pin Head Screw Cover Plate Screw (Plated) Bracket Sm
PAGE 3
First install the toilet bowl as per manufacturers’ specifications and instructions. Attach flush arm (A) on the brass cradle (X) mounted on the right side of the wood tank (A7). Hook the end of the pull chain (C) to the flush arm and flapper chain to the opposite side. (Fig 1) Make sure and check that the refill tube (A5) is inserted on top of the overflow pipe. (Fig 2) To mount molding bracket (D), locate the centerline on the wall behind the bowl and mark tank height.
PAGE 4
7" Tube (G) Fasten conversion panel (E). Place cover plate (F) on top of conversion panel (E) and secure with cover plate screws (T4).