Installation Guide

ManualsBrandsThe Tile Doctor ManualsFlooringStarlike EVO 110 5.5 lbs. Grigio Perla

Application data

with fast-setting adhesive: 4 hours

with mortar: 7-10 days

Wall application

with normal-setting adhesive: 24 hours

with fast-setting adhesive: 4 hours

with mortar: 2-3 days

Mixing ratios:

Component A: 93.7 parts by weight

Component B: 6.3 parts by weight

The two components are pre-measured in their respective packaging

Mix consistency:

Thixotropic paste

1.55 kg/l

≥ 2

Mixture life:

About 1 hour at T = +23°C / 73,4°F

Application temperatures allowed:

From +10°C to +30°C / From +50°F to 86°F

Recommended application temperature:

From +18°C to +23°C / From + 64,4°F to 73,4°F

24 hours at T = +23°C / 73,4°F

Ready for use:

5 days at T = +23°C / 73,4°F

Joint width:

From 1 to 15 mm (0,039 - 0,59 in)

EXCLUSIVE DISTRIBUTOR FOR USA

Tile Doctor

www.TileDoctor.com

877-TileDoc (845-3362)

Made In Italy

Application

STARLIKE EVO

1 Empty completely all the contents of the catalyst (B) onto the paste (A).

2 Special ﬁnishes: pour the additive onto the paste and mix slowly.

Mix at slow speed using an electric drill equipped with mixing paddle. Scrape the walls of the bucket to eliminate all parts of non-catalysed

product.

The joints must be dry. Introduce the mortar into the joints using the suitable green rubber ﬂoat (Art. 946GR) spreading diagonally across the

joints. Remove the excess product.

The grout must be cleaned while the product is still wet. Sprinkle clean water. Initial cleaning using a moistened white felt (art. 109/GBNC)

making circular movements. Ensure no water enters the joints.

6 Now perform a second cleaning with a rigid cellulose sponge (art. 128G0001).

Any stains of the transparent product can be removed after 24 hours or anyway after the gap has hardened. Use Haze Remover.

Spread Haze Remover with the white felt.

8 Leave on for 15-30 minutes. Scrub the surface with the white felt.

9 Rinse with clean water. Dry immediately with a clean cloth and do not wait for the evaporation of the rinse water.

Litonet EVO

Litonet Gel EVO

Art. 946GR Art. 109/ G Art. 128/ G HAZE REMOVER

Summary of content (1 pages)

PAGE 1
STARLIKE EVO Made In Italy Application 1 B A Empty completely all the contents of the catalyst (B) onto the paste (A). 2 Special finishes: pour the additive onto the paste and mix slowly. 3 Mix at slow speed using an electric drill equipped with mixing paddle. Scrape the walls of the bucket to eliminate all parts of non-catalysed product. 4 The joints must be dry. Introduce the mortar into the joints using the suitable green rubber float (Art. 946GR) spreading diagonally across the joints.