Assembly Manual Owner’s Manual and Assembly For Model TS6439 Corner TheraManual 1.26.
CONGRATULATIONS! Your recent purchase of a TheraSauna® is a step towards a lifetime of better health and well-being. Health and medical experts agree TheraSauna® is one of the finest products of its kind worldwide. We welcome you to the TheraSauna® family and wish you many years of enjoyment. Table of Contents Saunas…………………….…...2 Parts List……………….........3-6 Sauna Location…………..........7 Assembly Tips…………….......8 Assembly Instructions……..9-10 Electric Power…....……..…....11 Wood Characteristics …...…...
Before assembling your TheraSauna® please check the parts you have with the enclosed parts list. Parts List Figure 1 Figure 2 Sauna control box will face out. Face Up Bottom/Floor Quantity 1 Right Back Wall Quantity 1 Figure 3 Figure 4 Left Side Wall Quantity 1 Sauna wall has a sticker designating “right or left” When installed this panel will face into the sauna.
Figure 5 Figure 5 Front Wall Quantity 1 TheraSauna® front wall pictured will differ slightly from TS4746, TS5753, TS8454 & TS7754 models. Outside View Finished side will face out. Figure 6 Inside View Figure 7 Right Side Wall Quantity 1 Sauna wall has a sticker designating “right or left” When installed this panel will face into the sauna.
Figure 8 Figure 9 Front view Front view Left Bench Support Panel Right Bench Support Panel Quantity 1 Quantity 1 Figure 10 Left Bench Quantity 1 Figure 11 Reversible bench, one side is contoured for sitting. The other side is flat for lying down. Serial number is on the flat side underneath of the bench.
Figure 13 Figure 14 Light Fixture Light Mounting Screw Quantity 1 Quantity 1 Figure 15 Figure 16 Hex Wrench Bolts Quantity 1 Quantity 11 Figure 17 Door Handle Quantity 1 6
SAUNA LOCATION The TheraSauna® should be installed only inside a home or other enclosed structure with a flat leveled floor and a 20 Amp dedicated outlet in close proximity. Saunas must be directly plugged into woutlets; no extension cords should be used. Select a location that will be convenient for you and will provide you with maximum accessibility. Outside placement will void the warranty. WARNING! This unit is manufactured for indoor use only.
FOR YOUR SAFETY 1. Electrical and/or Light Receptacles shall not be installed inside the TheraSauna® room. 2. Do not add any locking or latching systems to the door of your TheraSauna®. Malfunction of which could cause entrapment inside the sauna. 3. The TheraSauna® comes with a sliding roof vent to provide proper ventilation to allow in fresh air if so desired. Keep vent closed when heating sauna. ASSEMBLY TIPS All assembly instructions are included with your TheraSauna®.
ASSEMBLY INSTRUCTIONS FOR THERASAUNA® 1. Place base/floor (Figure 1, page 3) on a solid flat level surface with 5 supporting blocks down. Note: The three small blocks on the top of the base go towards the back. 2. Stand right back wall (Figure 2, page 3) on the right back top edge of base with channeled top up. Make sure to center wall along back edge of base. Note: Base should extend out from each end of wall. 3.
Fully Assembled TheraSauna. 9. Place the right side wall (Figure 6, page 4) on the right front side of base. Lift the right side wall 2” above the floor to allow the hinge clips on the left side to lock into the hinge clips on the right side of the front door panel (Figure 5, page 4). Slide the wall down into position. Note: Make sure the panels are securely locked together at top and bottom.
USE Always consult a physician before beginning a sauna program. You may wish to begin with shorter sessions, 10 – 20 minutes, in the TheraSauna® and work up to 30 – 60 minutes per session, as you feel more comfortable and familiar with the effects. Begin at a lower temperature setting and work up to one that is comfortable for you. ELECTRICAL POWER REQUIREMENTS TS6439 – 110V-125V – 20 Amp 60 Hz dedicated wall receptacle.
WOOD CHARACTERISTICS Each tree has its own characteristics that are unique to it alone. These features include differences in color and grain directions that are produced by nature in every tree. These variations create the beauty and style found in fine wood. Since these differences in texture and grain affect the final finish, it is impossible to guarantee an exact match in finish between any two pieces, even though identical finishing processes are applied.
THERASAUNA® DISCLAIMER Disclaimer QCA Spas, Inc. (manufacturer of TheraSauna®) and its affiliates do not provide medical advice, education or treatment. The information contained in this manual is for general information purposes and is not intended to address individual medical conditions. Infrared heat may not be right for you and the information herein should not be relied upon in making decisions about your health. Always consult your physician for medical advice.
This symbol designates that these saunas are listed by Intertek Testing Services NA Inc. for use in the United States and Canada.