Installation Guide

Page. 22

Installing Grease Trays, Filters

and Spacers

Install Filters and Grease Trays

NOTE: DO NOT use burners, elements, or oven while

hood is disassembled.

1. Turn the fan and lights off.

2. Remove all plastic from hood pieces.

3. Insert in the following order:

• Grease Tray — Insert in rear tray. Grease trays

must be in place before installing the filters. Push

the grease tray in and down inside the grease tray

trough.

• Filters — start with inserting the filter in the

middle and work out to the ends. Slide the filter

up, toward the front of the hood, then push down

on top of the grease tray

• Filter spacers — If applicable, insert the filter

spacers on the left and right ends. Push up, slide

toward the front of the hood, then push in at the

bottom.

4. Reverse the above directions to remove the grease

tray, filters and filter spacer. Ensure filters are cool and

grease has congealed before removal.

Heat Lamp Installation

Note: Only on PHxxGWS models.

• Turn heat lamp clockwise to install.

• Replace lamp with either a PAR-38 175W heat lamp or

a PAR-40 250W heat lamp.

Refer to the Use and Care Guide for additional

information.

(1) Hood canopy (2) LED lights

(3) Touch control panel (4) Heat lamps

(5) Baffle filters (6) Grease trays

(7) Grease tray trough (8) Filter spacers

View may vary