Quick Start Guide

9
Electrical Connection
Avoid Electrical Shock Hazard!
Do not work on an energized circuit. Doing so
could result in serious injury or death. Only qualified
electricians should perform electrical work. Do not
attempt any work on the dishwasher electric supply
circuit until you are certain the circuit is de-energized.
To avoid possible injury or property damage, care
should be exercised when the dishwasher is installed
or removed to reduce the likelihood of damage to the
power cord.
Avoid Fire Hazard!
Make sure electrical work is properly installed and
checked by qualified electricians.
Make sure there are no loose electrical connections.
Make sure all electrical connections are properly made.
WARNING
GROUNDING INSTRUCTIONS
The dishwasher must be properly grounded before operating.
This appliance must be connected to a grounded metal per-
manent wiring system or an equipment grounding conductor
must be run with the circuit conductors and connected to the
equipment grounding terminal or lead on the dishwasher.
Do NOT use extensions cords.
Make sure that the dishwasher is connected to a suitable
ground in compliance with all local codes or, in the absence of
a local code, with the NATIONAL ELECTRICAL CODE in the
United States or the CANADIAN ELECTRIC CODE C22.1-lat-
est edition in Canada as well as any provincial/state or munici-
pal or local codes that apply.
Note: Installations employing a Receptacle - The accessory
cord kit, Model SMZPC002UC, designed for connection to
a receptacle is not provided, but can be ordered through
Customer Service by calling 1-800-944-2904. Make sure the
household receptacle meets the electrical supply requirements
as well as national and local codes. If you choose to permanently
connect to hardwiring, follow the next steps.
DISHWASHER ELECTRICAL RATING
Volts Hertz Amperes Watts
120 60 12 1,440
(max)
ELECTRICAL SUPPLY
The customer has the responsibility of ensuring that the dish-
washer electrical installation is in compliance with all national
and local electrical codes and ordinances. The dishwasher is
designed for an electrical supply of 120V, 60 Hz, AC, connect-
ed to a dishwasher-dedicated, properly grounded electrical
circuit with a fuse or breaker rated for 15 amps. Electrical sup-
ply conductors shall be a minimum #14 AWG copper wire rat-
ed at 75°C (167°F) or higher.
!