User Manual

Getting to know your appliance en-us
13
Specification and Performance Data Sheet
Only for appliances with filter model: 9000 777 508
When using replacement cartridge: 9000 674 655
The concentration of the indicated substances
dissolved in water entering the system was reduced
to a concentration less than or equal to the
permissible limit for water leaving the system as
specified in ANSI/NSF Standard 42 and Standard
53.
Capacity: 739.68 gallons/2,800 liters
Contaminant Reduction Determined by NSF testing.
* Based on the use of Cryptosporidium parvum
oocysts.
It is essential that the manufacturer's recommended
installation, maintenance and filter replacement
requirements are carried out as specified. See
manufacturer's documentation for warranty
information.
Note: While the testing was performed under
standard laboratory conditions, actual performance
may vary.
More detailed information on the prices of spare
parts is available from your local appliance dealer or
parts vendor.
9 WARNING
TO REDUCE THE RISK ASSOCIATED WITH
INGESTION OF CONTAMINANTS:!
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before and after connection to the
system. Systems certified for cyst reduction
may be used on disinfected water that may
contain filterable cysts.
EPA Establishment Number 10350-MN-005
9 CAUTION!
To reduce the risks associated with property
damage due to water leakage:
■ Read and follow user instructions before
installation and use of this system.
■ Installation and use must comply with all state
and local plumbing codes.
■ Do not install if water pressure exceeds
120 psi/827 kPa. If your water pressure
exceeds 80 psi, you must install a pressure
limiting valve.
■ Contact a plumbing professional if you are
uncertain how to check your water pressure.
■ Do not install where water hammer conditions
may occur. If water hammer conditions exist,
you must install a water hammer arrester.
Contact a plumbing professional if you are
uncertain how to check for this condition.
■ Do not install on hot water supply lines. The
maximum operating water temperature of this
filter system is 100 °F (38 °C).
■ Protect filter from freezing. Drain filter when
temperatures drop below 33 °F (1 °C).
■ The disposable filter cartridge must be
replaced
no later than every 6 months at the rated
capacity, or if a noticeable reduction in flow
rate occurs.
Manufactured by:
■ 3M Purification Inc.
400 Research Parkway
Meriden, Ct 06450
Tel. [phone]
Tel. [phone]
3M is a trademark of 3M Company used under
license. NSF is a trademark of NSF International.
© 2013 3M Company. All rights reserved.
System tested and certified by NSF
International against ANSI/NSF Standard
53 and Standard 42 for the reduction of
the claims specified on this Specification
and Performance Data Sheet.
Contaminant Reduction Chlorine Taste and
Odor
Nominal Particulate Class 1,
>/= 0.5 to <1.0 μm
Cysts* Turbidity
Average Influent 2.1 mg/L 9,100,000 pts/mL 170,000 cysts/L 11 NTU
NSF specified Challenge Concentration 2.0 mg/L +/- 10% At least 10,000 particles/mL Minimum
50,000 cysts/L
11 +/- 1 NTU
Avg. % Reduction 97.6% 98.8% 99.99% 98.1%
Average Product Water Concentration 0.05 mg/L 111,817 pts/mL 0.001 cyst/L <1 NTU
Max. Permissible Product Water Concen-
tration
N/A N/A N/A 0.5 NTU
NSF Reduction Requirements >/=50% >/=85% >/=99.95% 95%
NSF Test Report J-00121313 J-00099871 J-00109715 J-00099885
Application Guidelines/Water Supply Parameters
Service Flow 0.75 gpm
(2.83 lpm)
Water Supply Potable Water
Water Pressure 30 ... 120 psi
207 ... 827 kPa
Water Temperature* 33 °F ... 100 °F
0.6 °C ... 38 °C