Installation guide

Installation Instructions English | 7 |
Advance Planning
Before You Begin
CAUTION
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Parts Included
Hood assembly (lamps and blower
already installed)
10” Metal transition with backdraft
damper

Fastener assortment*
* Hardware provided is for mounting through standard
thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of
mounting situations.
Tools and Parts Needed
 Ducting as needed (refer to Equivalent Duct Lengths
for Commonly Used Transitions Table)
 Aluminum tape (DO NOT use duct tape)
 1/2’’ (13 mm) Conduit if required (follow local codes)
 1’’ (25.4 mm) Strain relief
 Ducting as needed
 Blower
 Flat head and Phillips screwdrivers
 Drill with 3/16’’ (4.76 mm) drill bit
 Circular saw or jigsaw
 3/8’’ (9.52 mm) nut driver or socket and ratchet
 Wire stripper
 Protective work gloves
IMPORTANT: DO NOT throw away any packaging until
appliance is fully installed.
Optional accessories available for separate
purchase.
Refer to www.thermador.com for more details.
 DCT3016W – 16” tall Duct Cover Kit 30”
 DCT3616W – 16” tall Duct Cover Kit 36”
 DCT4816W – 16” tall Duct Cover Kit 48”
 DC30MTW – Telescopic Duct Cover Extension Kit 30”
 DC36MTW – Telescopic Duct Cover Extension Kit 36”
 DC48MTW – Telescopic Duct Cover Extension Kit 48”
 RECHMWB30 – Recirculating Kit 30”
 RECHMWB36 – Recirculating Kit 36”
 CHFILT3036 – Charcoal Filter Replacement Kit
 REMCPW – Built-In Remote Control Accessory