Installation instructions
Installation InstructionsEnglish | 14 |
Wall installation
1. Turn power OFF at the service panel. Lock service panel
to prevent power from being turned ON.
2. After the hood installation height has been determined,
draw a horizontal line at a distance above the cooktop
equal to the recommended hood installation height plus
10
4
16’’ (260 mm). This line is the mounting location of
the upper mounting screws.
3. Find the centerline of the hood. Draw a vertical line
along this centerline up to the horizontal line drawn
in Step 2.
4. Mark the screw hole locations indicated in the diagram.
Center
Line
AA
B
D
E
B
WALL
C
30” (76.2 cm) 36” (91.4 cm) 48” (121.9 cm)
A
6
15
16” (17.5 cm) 11
4
16” (28.5 cm) 11
4
16” (28.5 cm)
B
10
13
16” (27.5 cm) 10
13
16” (27.5 cm) 10
13
16” (27.5 cm)
C
10
15
16” (27.8 cm) 10
15
16” (27.8 cm) 10
15
16” (27.8 cm)
D
7
3
4” (19.7 cm) 7
3
4” (19.7 cm) 7
3
4” (19.7 cm)
E
13
16” (2 cm)
13
16” (2 cm)
13
16” (2 cm)
5. If drywall is present, cut away enough drywall to expose
2 vertical studs at the indicated holes location. Install
two horizontal supports between two wall studs at the
bottom and upper mounting holes installation location.
6.
of the studs. Use cleats behind both sides of the support
to secure wall studs.
7.
View from rear
Mounting
Support
Centerline of
Installation space
IMPORTANT: Framing must be capable of
supporting 100 lbs.
Cleats
8. Cut holes at marked locations for duct and electrical
wiring.
Mounting the hood
1. Drive a mounting screw (from the hardware package)
partway into each center of the narrow neck of the
keyhole slots marked on the wall’s support frame.
2. Install the 2 pieces of the selected screws on the
mountings screws location (see the image). Leave a
1
4’’
(6.4 mm) gap between the wall and the back of the
screw head to slide range hood into place.
1
/
4
"
(6.4)
3. Fix the wiring conduit of the hood.