Installation instructions
Installation InstructionsEnglish | 18 |
Chimney Extension Installation
(optional)
On some models, optional duct covers and telescoping
and ceiling in wall mount installations. Chimney extensions
ceilings. Telescoping extensions accommodate 12’ (3.6 m)
ceilings.
Model Duct Cover
Telescopic
Extension
HMWB30WS DCT3016W DC30MTW
HMWB361WS
DCT3616W
DCT3616W
DC36MTW
DC36MTW
HMWB36WS
HMWB481WS DCT4816W DC48MTW
Duct Cover Extension Installation
IMPORTANT NOTE: Secure the Chimney Wall Hood to the
wall before installing the Chimney Extension. See “Moun-
ting the Hood” on page 14 before securing the actual
Extension.
1. Installation of the chimney hood should maintain a
minimum height of 30” (762 mm) from the bottom of
the hood to the cooking surface. To determine
placement of the hood with a Chimney Extension, the
height of the chimney extension must be calculated.
2. From inside of hood, screw the supplied
5
8’’ (16 mm)
sheet metal screws through the holes on each side and
along the front into bottom of the extension, as shown
in below. (Screw quantity is dependent on hood size.)
Telescopic Duct Cover Installation
IMPORTANT: Secure the Chimney Hood to the wall after
installing the Extension Mounting Bracket, but before
installing the Telescoping Chimney Extension. See
“Wall Installation” on page 14 before securing the actual
Extension.
Securing the Telescoping Chimney Extension Bracket
1. Ensure that the minimum height of 30” (762 mm) from
the bottom of the hood to the cooking surface will be
maintained.
2. Locate two studs at the mounting location.
inches (mm)
A
B
Max. 61”
(1550)
Min. 31”
(787)
30”
(762)
31”
(787)
11”
(280)
Model A B
30” 12” (305) 30” (762)
36” 12” (305) 36” (914)
48” 12” (305) 48” (1219)