Wall Hood Care and Use Manual

ManualsBrandsThermador ManualsVentilation HoodHSB

READ AND SAVE THESE INSTRUCTIONS

CARE AND USE FOR

HS - HST - HSB WALL HOODS

(Turn Book Over for Installation

Instructions)

HSB

HST

5551 McFadden Avenue, Huntington Beach, CA 92649  800/735-4328

LI164A

Summary of content (6 pages)

PAGE 1
CARE AND USE FOR HS - HST - HSB WALL HOODS (Turn Book Over for Installation Instructions) READ AND SAVE THESE INSTRUCTIONS HSB HS HST 5551 McFadden Avenue, Huntington Beach, CA 92649 800/735-4328 © BSH Home Appliances Corp.
PAGE 2
CONTROL PANEL HSB SERIES HOODS LIGHT Blower ON indicator light button OFF Light: OFF: LO: MED: HI: LO MED HI Light ON-OFF button Blower OFF button Blower speed button 1 (low) Blower speed button 2 (med) Blower speed button 3 (high) HS SERIES HOODS Off : Pressing button once turns blower off and resets control. Fan Speed : Pressing button once, from an off state, turns the blower F on low.
PAGE 3
HST SERIES HOODS Off : Pressing button once turns blower off and resets control. Fan Speed : Pressing button once, from an off state, turns the blower on low. Each successive press of the button increases the fan speed until high where the fan cycles back to the low speed. The LEDs above this button indicate the current fan speed. When the fan is on, the corresponding LED is illuminated. 1 – Low 2 – Medium 3 – High Delay Shut Off : Press to turn fan on high for 5 minutes.
PAGE 4
HOOD OPERATING INSTRUCTIONS The blower should be turned on for a few minutes before cooking in order to establish air currents upward through the hood. Thus when heat, smoke, moisture, grease and cooking odors are produced, they will be carried outside instead of drifting into other rooms. Use the low speeds for normal use and the higher speeds for strong odors or fumes. Drafts across the range or cooktop will cause the escape of heat, smoke, moisture, grease and cooking odors from the hood.
PAGE 5
LIGHTS NOTE: Turn off the lights and fan. Allow the lights to cool before handling. If new lights do not operate be sure lights are inserted correctly before calling service. Replace Lights (HS and HST series hoods only) Using a flat edge from a screwdriver or equivalent tool pry loose the lens cover as shown in Figure 2. Remove the damaged light and replace with a new 12 Volt, 20 Watt (maximum) halogen light made for a G-4 base. Follow package directions and do not touch new light with bare hands.
PAGE 6