Design Guide

GAS COOKTOPS | INSTALLATION
1.800.735.4328 | THERMADOR.COM
189
GAS COOKTOPS
INSTALLATION
30-INCH & 36-INCH GAS COOKTOP CABINET REQUIREMENTS
Depth from Back Wall
Cabinet 13" (33cm) max.
Hood Depth - 24" (61cm) max.
Centered Over Cooktop
Rear Wall - 3"(8cm)
Right Side
13" (33cm) min.
Left Side
13" (33cm) min.
18" (46cm) min.
Above Counter - 30" (76 cm) min. to
Combustible Surface
SGS(X)30 - 30" (76cm) min.
SGS(X)36 - 36" (91cm) min.
Dimension requirements are for combustible
surfaces. When the surface is protected by a
material listed by UL as a Floor Protector and Wall
Shield covered with not less than No. 28 MSG
sheet metal 0.015 inch (0.38 mm) stainless steel,
0.024 inch (0.6 mm) aluminum or copper, it is
considered noncombustible and some dimensions
may be reduced. For a noncombustible surface
over the cooktop, the minimum clearance is 24"
(61 cm) rather than 30" (76 cm).
WARNING: To reduce the risk of ignition of nearby
combustible materials, install the countertop with
a minimum distance of 13" (33 cm) from side walls
and 3" (8 cm) from back wall.)
NOTE: All measurements given have to be
precisely followed. If nonstandard cabinets are
used, make sure they are installed with minimum
dimensions shown.
Plan the installation of the unit so that the power
cord, gas shut-off valve and gas pressure regulator
are accessible from the front of cabinet.
30-INCH & 36-INCH GAS COOKTOP INSTALLATION ABOVE
A THERMADOR BUILT-IN OVEN
27
1
/16"
(687mm)
29
1
/16"
(738mm)
24
7
/16"
(621mm)
36"
(914
mm)
SUMP
COOKTOP
OVEN
COUNTERTOP
Gas
Connection
4
3
/16"
(106mm)
3
13
/16"
(97mm)
3"(76mm)
5
11
/16"
(144mm)
6
3
/4"
(172mm)
1
1
/8"
(28mm)
3
/
8
"
(9mm)
4
3
/4"
(121mm)
Note: Dimensions based on standard countertop height (36" with 4
3
/4" toe kick
including base plate).
The built-in oven can be installed below the gas cooktop as long as there is no
contact between the bottom of the cooktop and the top of the oven.
Sump applies to 30-inch Wall Ovens onl
y
.
28
1
/4"
(718mm)
TOE KICK