Installation Manual

10
Connecting the Hot Water Supply
There are two plastic corrugated hoses that exit the back of
WKHGLVKZDVKHU7KHODUJHUKRVHZLWKWKHEUDVV¿WWLQJRQWKH
end, is the water supply hose to the dishwasher (the other
KRVHLVWKHGLVKZDVKHUGUDLQKRVH<RXZLOOQHHGDƎ[
3
/
4
Ǝ
(76 x 45 mm) opening through the cabinet to pass the dish-
washer water supply line through toward the shut off valve.
To connect the hot water supply:
$VVHPEOHWKHZDWHUVXSSO\DGDSWRU¿WWLQJ+IURPWKH
parts bag onto the dishwasher water supply hose. This
FRQQHFWLRQGRHVQRWUHTXLUH7HÀRQEUDQGWDSH
3DVVWKH GLVKZDVKHU ZDWHU VXSSO\ OLQH ZLWK DWWDFKHG
adaptor through the opening toward the water shut off
valve. Take care not to allow the hose to kink or twist
behind the dishwasher.
3. Connect the dishwasher water supply line with adaptor to
the water shut off valve. You will need to use an approved
GLVKZDVKHUZDWHUVXSSO\OLQHZLWKWKHFRUUHFW¿WWLQJVIRU
this connection. Always use the appropriate seal when
making plumbing connections.
NOTE: The end of the dishwasher water inlet hose is
heavy and will need to be supported. It is best to lay the
HQGRQWKHFDELQHWÀRRUDVVKRZQLQFigure 9.
4. After all connections are made, turn on the hot water and
check for leaks.
The dishwasher drain hose may be connected to the house-
KROGRU¿HOGGUDLQSOXPELQJLQRQHRIIRXUZD\V<RXZLOOQHHG
a 1¼" diameter hole in order to pass the drain hose through
the cabinet.
1 Directly under the sink dishwasher drain connection, as
shown in Figure 11.
2 Directly to a disposer dishwasher drain connection, as
shown in Figure 12.
3 To the under sink dishwasher drain connection through
an air gap, as shown in Figure 13.
4 To a disposer dishwasher drain connection through an air
gap, as shown on Figure 14.
IMPORTANT NOTES:
· If local ordinance require an air gap, install it according
to the manufacturer’s instructions.
· If the dishwasher drain hose is to be connected to a
disposer dishwasher drain connection, remove the plug
from the disposer’s dishwasher drain connection.
· The dishwasher drain hose must have one place along
LWVOHQJWKWKDWLVVHFXUHO\DWWDFKHGƎPPDERYH
WKHFDELQHWÀRRU
· The drain hose length can be extended if necessary. The
maximum length of the drain hose, including the hose
OHDGLQJWRWKHDLUJDSLVƎPP
Figure 9
Figure 13 Figure 14
Figure 11
Figure 10
Non-Metallic Tie
MIN.
20"
MIN.
20"
Non-Metallic Tie
Figure 12
Remove
plug
Drain Connections
max 43” (1100mm)
G
G
G
G
min 20Ǝ (508mm)
max 43Ǝ (1100mm)
min 20Ǝ (508mm)
max 43Ǝ (1100mm)








10