Installation Instructions
Table Of Contents
- Table of
- Safety
- Safety
- Installation instructions
- Planning information
- Ventilation requirements
- Installation clearances
- Unpacking and setting the rangetop
- Gas requirements and hookup
- Electrical requirements and connection for gas units
- Low backguard installation (optional)
- Burner test
- Final checklist
- Renseignements de planification
- Exigences en matière de ventilation
- Espaces libres pour l’installation
- Déballage et mise en place
- Exigences pour l'alimentation du gaz et raccordement
- Exigences électrique et branchement pour les unité au gaz
- Installation de la plaque de protection basse (optionnel)
- Test de brûleurs
- Liste de vérification
- 9 INSTRUCCIONES IMPORTANTES DE SEGURIDAD LEA TODAS LAS INSTRUCCIONES ANTES DE CONTINUAR
- Información de planificación
- Requisitos de ventilación
- Espacios libres para la instalación
- Mover y anclaje la parrilla
- Requerimientos de gas y conexiones
- Requerimientos eléctricos y conexión para unidades de gas
- Instalación de la consola trasera de protección (opcional)
- Probar el quemador
- Lista de chequeo final
- Blank Page
- Blank Page
Page. 15
Low backguard installation
(optional)
9 WARNING
Fingers or hands could get pinched when installing
the backguard. Severe injury could result. Use
extreme caution and wear thick protective gloves to
avoid potential laceration to finger or hand while
sliding the backguard down onto the range.
9 WARNING
To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.
Installation methods will vary upon need. Before you
begin read these instructions carefully. Observe all local
codes and ordinances.
To install the low backguard
1. Depending on model, remove the 2 or 3 stainless Torx
screws in the front face of the included Island Trim. Lift
up to fully remove the Island Trim.
2. Slide the support brackets of the Low Backguard
between the two rangetop chassis back panels.
3. Secure the back with 8 x 1½'' (38 mm) screws.
4. Secure the front of the Low Backguard to the
rangetop with 2 or 3 x ½'' (12.7 mm) screws.
9½"
(239)
9½"
(239)
9½"
(239)