Installation Instructions
Table Of Contents
- Table of
- Safety
- Safety
- Installation instructions
- Planning information
- Ventilation requirements
- Installation clearances
- Unpacking and setting the rangetop
- Gas requirements and hookup
- Electrical requirements and connection for gas units
- Low backguard installation (optional)
- Burner test
- Final checklist
- Renseignements de planification
- Exigences en matière de ventilation
- Espaces libres pour l’installation
- Déballage et mise en place
- Exigences pour l'alimentation du gaz et raccordement
- Exigences électrique et branchement pour les unité au gaz
- Installation de la plaque de protection basse (optionnel)
- Test de brûleurs
- Liste de vérification
- 9 INSTRUCCIONES IMPORTANTES DE SEGURIDAD LEA TODAS LAS INSTRUCCIONES ANTES DE CONTINUAR
- Información de planificación
- Requisitos de ventilación
- Espacios libres para la instalación
- Mover y anclaje la parrilla
- Requerimientos de gas y conexiones
- Requerimientos eléctricos y conexión para unidades de gas
- Instalación de la consola trasera de protección (opcional)
- Probar el quemador
- Lista de chequeo final
- Blank Page
- Blank Page
Page. 16
Burner test
9 WARNING
To prevent flare-ups and avoid the creation of harmful
by-products, do not use the cooktop without all
burner caps and all burner grates properly positioned.
9 WARNING
To prevent burns, do not touch burner caps or grates
while hot. Turn the cooktop off and allow the burners
to cool.
Install any loose components, such as burner caps and
grates that may have been removed earlier. Be certain that
burner caps seat properly into the burner bases. Before
testing operation of the appliance, verify that the unit and
the gas supply have been carefully checked for leaks and
that the unit has been connected to the electrical power
supply. Turn the manual gas shut-off valve to the open
position.
The burner caps must be properly placed on the burner
bases for the cooktop to function properly. If the burner
cap is not properly placed, one or more of the following
problems may occur:
• Burner flames are too high.
• Flames shoot out of burners.
• Burners do not ignite.
• Burner flames light unevenly.
• Burner emits gas odor.
Burner cap placement
Each cap has a letter (B, D, or F) cast in the underside of
the cap that corresponds to a letter (B, D, or F) cast in the
burner base that is attached to the appliance.
To place the burner caps
1. Place each burner cap on its correct burner base per
its corresponding letter designation.
2. Place burner cap gently on top of base so that the
prongs of the burner base fit snugly into the groove of
the burner cap.
Checking the burner cap placement
• Check each burner to make sure there is no gap
between the burner cap and burner base.
• You may gently try to move the burner caps from side
to side to check if the caps are properly placed on the
burner bases.
• When properly placed, each burner cap will rest flat
on top of its burner base, and completely cover the
star-shape of the burner base when viewed from the
top as shown below.
Burner grate placement
To install the burner grates
1. Place grates flat-side down and align into the
rangetop recess.
2. Grates should rest flush against each other and
against the sides of the recess.