® CARE AND USE MANUAL for PH and PHI SERIES PROFESSIONAL WALL and ISLAND HOODS PH30ZS, PH36ZS, PH42ZS, PH48ZS, PH54ZS, PHI48ZS and PHI60ZS READ AND SAVE THESE INSTRUCTIONS
A special message to Our Customers, Thank you for buying a Thermador Hood. Please take the time to read and understand this entire booklet before using your new appliance. We hope that the information in this manual will help you easily operate and care for your Hood with years of satisfaction. Please contact us if you have any questions or comments. Thermador’s address and phone number are listed on the last page of each language section in this booklet. TABLE OF CONTENTS Important Safety Instructions ...
IMPORTANT SAFETY INSTRUCTIONS WARNING WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: TO REDUCE THE RISK OF INJURY TO PERSONS, IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING: 1 . Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer (800/735-4328). a ) SMOTHER FLAMES with a close-fitting lid, cookie sheet, or other metal tray, then turn off the gas burner or the electric element.
OPERATING THE HOOD The blower should be turned on for about 5 minutes before cooking in order to establish air currents upward through the hood. Thus when heat, smoke, moisture, grease and cooking odors are produced, they will be carried outside instead of drifting into other rooms. Use the low speeds for normal use and the higher speeds for strong odors or fumes. Drafts across the range or cooktop will reduce the effectiveness of the hood. Such drafts should be prevented when possible.
HOOD CONTROL BUTTONS OFF HEAT SENSOR Pressing button once turns ventilator off and resets control. FAN SPEED Pressing button once, from an off state, turns the ventilator on low. Each successive press of the button increases the fan speed until high where the fan cycles back to the low speed. • The LEDs above this button indicate the current fan speed. When the fan is on, the corresponding LED is illuminated. 1 – Low 2 – Medium 3 – High DELAY SHUT OFF • Press to turn fan on high for 10 minutes.
CARE AND CLEANING To Clean Hood Surface • • • • • For general care, wipe the outside of the stainless steel with sudsy water or household cleaners such as Fantastic ® or Formula 409 ®, rinse well and dry with a clean soft cloth to avoid water marks. ® Wipe and dry stainless steel in the same direction as the grain. Avoid using too much pressure, which may mar the surface. Do not use abrasive products such as steel wool.
MAINTENANCE LIGHTS NOTE: Turn off the lights and fan. Allow the lights to cool before handling. If new lights do not operate, be sure lights are inserted correctly before calling service. Halogen Light Replacement (for PH and PHI Model Wall and Island Hoods) • • Using a flat edge from a screwdriver or equivalent tool, pry loose the lens cover as shown in Figure 5. Remove the damaged light and replace with a new 12 Volt, 20 Watt (maximum) halogen light made for a G-4 base.
THERMADOR HOOD WARRANTY FULL ONE YEAR WARRANTY Covers one year from date of installation, or date of occupancy on a new, or previously unoccupied dwelling. Save your dated receipt or other evidence of installation/ occupancy date. Thermador Will Pay For: All repair labor and replacement parts found to be defective due to materials and workmanship. Service must be provided by a Factory Authorized Service Agency, during normal working hours. For a Service Agency nearest you, please call 800/735-4328.