Installation Instructions

Installation Instructions English | 21 |
Installing the Leg Covers
1. Remove plastic coverings from the stainless steel
covers.
2. Place the smaller cover, with cutouts facing up, inside
the larger cover with the openings of both stacked and
facing the back.
3. Beneath the range, wrap the cover assembly around
the leg.
4. Slide the outer cover up while the inner piece remains
on the floor. The mating part has dimples for which the
holes of the larger cover should seize. You should feel
a definitive click, letting you know that the cover
assembly has been mounted to the unit.
5. Secure the cover assembly through the dimpled holes
with (2) ½'' stainless steel Torx head screws (included),
as shown below.
6. Repeat for all visible legs.
• If additional leg covers are required, they may be
ordered from the service center by calling
1-800-735-4328 at no charge for up to one year
after purchase date of the appliance. When
ordering, refer to Leg Cover Kit part no. 00751305.
Toe Kick Panel (optional) (PA60RTKG)
1. Remove the screws securing the leg covers (see
Figure 22: “Leg Cover Mounting Holes”). Dismount the
leg covers from the extruded dimples.
2. Remove protective plastic covering from the Toe Kick
Panel.
3. Beneath the range, with the holes and flange facing up,
wrap the Toe Kick Panel around the base.
4. The mating part has extruded dimples on both sides for
which the holes of the Toe Kick Panel should seize.
You should feel a definitive click, letting you know that
the part has been installed.
Figure 20: Leg Covers
Figure 21: Range Dimples
Figure 22: Leg Cover Mounting Holes
TOOLS NEEDED
T-20 Torx head screwdriver or drill
Protective work gloves