Installation guide

Installation options
There are many different installation options.
These are limited only by the design of the kitchen and
the function of the finger guard.
Individual unit
Side-by-Side
Individual
appliances with partition
* Partition required!
IT] When 2 appliances are installed Side-by-Side,
the Basic Combination Side-by-Side Sealing kit
must be used to ensure a stable connection.
See the section on "Optional accessories" on
page 17.
%
Note
When dimensioning the partition for model 4, note
the thickness of the furniture fronts to prevent
damage if the doors are opened at the same time.
Use the Extreme Combination Side-by-Side
Heating kit if the gap between the appliances is
less than 6" (160 mm).
See the section on "Optional accessories" on
page 17.
Minimum thickness of the partition 5/s" (16 mm).
At the end of the kitchen units
If one side of the appliance is visible, a side panel must
be used.
The side panel must be connected firmly to the wall,
the floor and overhead furniture/fixtures before the
appliance is placed in the cavity.
The dimensions of the side panel are taken from the
opposite cavity wall. During installation ensure that the
cavity is square and the exact size.