Design Guide

ManualsBrandsThermador ManualsAppliancesFreedom Series 36 Inch Counter Depth Bottom Freezer Refrigerator, in Stainless Steel

228

FREEDOM

COLLECTION

PLANNING CHECkLIST

This custom product requires attention to the nest details. Did you remember to…?

Choose a desired conguration – side-by-side or stand-

alone columns (See pages 233-237 for details)

Plan the cutout height(s) – 84" (See pages 233-237 for details)

Plan the cutout width(s) – depends on conguration and

column width (See pages 233-237 for details)

Plan the cutout depth – 25" for North American style cabinets,

24" with installation frame accessory, 24" for European style

cabinets (See pages 233-237 for details)

Ensure the cutout interior (top and sides) is ush to the

appliance at a depth of min. 4", preferably 6" from face frame

(See pages 233-237 for details)

Ensure the cutout interior returns (top and sides) are nished

to match exterior at a depth of min. 4", preferably 6" from

face frame (See pages 233-237 for details)

Ensure proper clearance for appliance doors including

handle(s) – check for interference with other appliances,

open or closed cabinets and doors, nearby walls (See page

230 for details)

Properly site the electrical outlet and (if applicable) water box

(See page 232 for details)

Choose the door panel type – at (TFL series) or chiseled

(TCH series) stainless steel accessory panels or design custom

panel(s) (See page 240 for details)

Ensure the reverse of any custom panel is nished to match

the exterior

Choose the handle style – Professional (PR36HNDL10),

Masterpiece

(MS36HNDL10) or custom

Choose the correct handle length – normally PR36HNDL10

or MS36HNDL10 – shorter handle (PR30HNDL10 or

MS30HNDL10) for 30" bottom freezer (T30IB800SP)

drawer only

Choose the toekick style – stainless (included with appliance)

or design custom toekick(s) (See page 238 for details)

Procure the proper installation accessories – stainless steel

frame kit (FRAMEKIT10) for framed installations in 24-inch

deep cutouts, heater kit (HEATRKIT10) for uncommon side-by-

sides (any combination not involving a freezer column) heater

kit for installations of columns that are not side-by-side, but six

inches or closer to one another, heater kit for humid areas (any

conguration or installation type) (See page 241 for details)

If applicable, procure the proper water lter accessories –

additional replacement lters (REPLFLTR10), lter by-pass

(SCRNFLTR10) for in-home water ltration system (See page

241 for details)