Installation Instructions
Installation InstructionsEnglish | 20 |
Recirculating Kit (optional)
When used in recirculation mode, To Reduce the Risk of
Fire and Shock use only conversion kit Models
RECHMWB30 and RECHMWB36.
Model Recirculating Kit
HMWB30WS RECHMWB30
HMWB36WS RECHMWB36
If it is not possible to vent cooking fumes and vapors to
the outside, the hood can be used in the non-vented
(recirculating) version, using the recirculating kit.
Fumes and vapors are recycled through the round grid.
Before installing the recirculation kit
The Installation of the Recirculation kit affects the installa-
tion of the hood, so take into consideration the following
steps.
installing the recirculation kit.
there’s no need to provide cutouts on walls for vertical or
rear air discharge, since there is no need to install any Duct.
NOTE: Check that there is enough clearance and that
minimum height from the countertop to the bottom of the
hood is 30” (76.2 cm).
NOTE: The transition must not be installed, since no duc-
ting is necessary.
Wall Mount Installation
wall:
1.
tighten completely.
C
C
C
C
2.
go respectively into Side Slots on top of the hood and
frontward until stops.
3. Tighten the four screws C from inside of the hood.
4.
hood size).
5. Proceed to install hood as described on Wall Mount
Installation described at the Hood Installation Manual.
Charcoal filter
In the reciruclating mode, the air will be recirculated
and odors.
Cover the grill that protects the suction motor with the
to the pins on the sides of the motor protection grill.
NOTE:
replaced every 4-6 months (depending on hood usage).