Installation Guide

Page 17
Cut out ductwork opening in cabinet
1. Measure and mark where to cut the ductwork opening in the cabinet
based on the ducting option selected. Use the dimensions in the
illustration below to help plan how and where to provide duct access
through your cabinet.
INSTALLATION
CENTER LINE
HOLE FOR
1
7
/
8
” x 19”
(48 mm x 483 mm)
DUCT &
TRANSITIONS
INSIDE
CABINET BACK
INSIDE
CABINET FLOOR
1½”
(38 mm)
21”
(533 mm)
centered
4” (102 mm)
21”
(533 mm)
A
REAR CORNER OF
COOKTOP CUT-OUT
24¾” (629 mm)
4 ”
(105 mm)
/
8
1
5 ”
(149 mm)
/
8
7
4”
(102 mm)
Hole in Cabinet Floor
Dimension A
Using Flex Blower (Model
VTD600P & 8” (203 mm) round
duct straight down through
cabinet  oor.)
(1½"/ 38 mm left of installation
center line)
7¾ inches (197 mm)
2. Set downdraft into cabinet/countertop opening as far back as possible
and make sure it is level.
INSTALLATION
Measurements in
inches (mm).
3. Check that markings in cabinet line up with ducting coming from
downdraft.
4. Remove downdraft housing from cabinet.
CAUTION
Before cutting hole in cabinet for ductwork, check for interference
with  oor joists, wall studs, electrical wiring or plumbing.
5. Cut ductwork hole in cabinet - as well as holes in wall or  oor a necessary.
Mounting downdraft with recirculation kit
(UCVRECIRC)
If unit is to be installed using a recirculation kit, please follow the
installation instructions for the recirculation kit (UCVRECIRC) prior to
installing and mounting the downdraft in the cabinet.
Mount downdraft in cabinet
1. Set downdraft into cabinet/countertop opening as far back as possible
and make sure it is level.
2. Extend support legs and attach to bottom of cabinet with (2) screws
through each leg. Tighten nuts.
If cabinet bottom is removed: Use blocks as spacers between  oor and
support legs.
1
1
2 No. 10 x 0.500
WOOD SCREW