Installation Guide

Page 18
3. Extend upper support brackets and attach to sides of cabinet with (2)
screws through each bracket.
Installations using  exible blower only:
4. Extend blower support legs and secure them to bottom of cabinet with
a screw through each leg. Tighten (4) bolts to secure support legs to
 ex blower.
INSTALLATION
Gas cooktops only:
Install gas cooktop seal kit (UCV30ST,
UCV36ST) (purchase separately)
Available for application with gas cooktops - where proper sealing is required
and holes are required in cabinet base. Kit includes trim seal, toe-kick cover
grille, and cabinet hole cover grille.
2 No. 10 x 0.500
WOOD SCREW
1
FLEXIBLE
BLOWER
(4)
BOLTS
A
B
A
B
B
C
B
B
C
B Cut one 18¼” x 2½” (464 mm x 64 mm) OPENING (A)* in the
cabinet toe kick.
-- or --
Cut one 18¼” x 2½” (464 mm x 64 mm) OPENING (B) in the
cabinet side or back.
Mount one of the two metal grilles over this opening, using two
screws provided.
C If you chose to cut an opening in the toe kick - you must cut
another 18¼” x 2½” (464 mm x 64 mm) OPENING (C)* in the
cabinet  oor.
Mount the second metal grille over this opening.
* IMPORTANT NOTE
When using toe kick opening (A) with opening (C) in cabinet  oor:
Air must be able to  ow freely between these two openings - and
not restricted by cabinet structure or any other obstruction.