Installation Guide

Page 8
1 Parts Bag containing:
2 - Screws,
1/4-20 x .50
(12.7 mm)
Hex Head
2 - Screws,
No. 8-18 x .375
(9.5 mm)
Phillips
8 - Wood Screws,
No. 10 x .50 (12.7 mm)
Phillips Round Head
2 - End Cap Trim
1 - Plastic installation
template
(see page 13) 2 - Support legs2 - Support legs
1 - Electrical Panel1 - Electrical Panel
2 - Upper Support 2 - Upper Support
BracketsBrackets
1 - Special key1 - Special key
INST
ALLA
TION
MANUAL
MASTERPIECE
®
SERIES DOWNDRAF
T
VENTILA
T
OR
VENTILA
TEURS ENCASTRÉS SÉRIE MASTERPIECE
MD
VENTILADOR DE TIRO DESCENDENTE SERIE MASTERPIECE
®
MANUE
L
D'INS
TALLATION
MANUAL DE
INSTALACIÓN
InstallationInstallation
instructionsinstructions
USE
AND CARE
GUI
DE
G
UÍA
D
E USO Y
CUI
DAD
O
MASTERPIECE
®
SERIES DOWNDRAFT
VENTILA
TOR
GUIDE
D'UTILISA
TION
ET
D'ENT
RETIE
N
VENTILA
TEURS ENCASTRÉS SÉRIE MASTERPIECE
MD
VENTILADOR DE TIRO DESCENDENTE SERIE MASTERPIECE
®
Use and Care guide
Wiring diagram Downdraft Ventilator Housing
BEFORE YOU BEGIN
Installation review
This downdraft system can be used to exhaust cooking by-products
such as heat, steam, and smoke that may be created while cooking
using gas or electric cooktops. With its versatile design, there are six (6)
basic discharge options - left, right, rear, below, front and recirculation.
It is important to  rst plan your installation. The purchase of additional
accessories to complete the installation may be necessary.
It can be mounted in an island, peninsula, or conventional wall location.
The blower (purchase separately) and electrical panel can be mounted to
the downdraft unit, inside the cabinet, or in a convenient remote location.
This unit can be easily installed following these basic steps:
•
Plan the installation.
•
Cut out the countertop opening.
•
Prepare the downdraft housing.
•
Cut out the cabinet opening for discharge.
•
Mount the downdraft in the cabinet.
•
Install gas cooktop seal kit accessory, if applicable.
•
Connect the ductwork and install the blower.
•
Install downdraft electrical panel, if in remote location.
•
Install the cooking appliance.
•
Install end caps to downdraft.
•
Check the operation.
Note: the high level of air  ow of this appliance may effect the gas
 ame on some types of gas cooktops. This is NORMAL and will cause
no harm, but can be corrected by lowering the speed of the blower.
Parts supplied
Tools needed
•
Measuring tape
•
Pencil
•
Phillips screwdriver no. 2
•
Nut drivers - 11/32” (8.7 mm), 3/8” (9.5 mm), 7/16” (11.1 mm)
•
Box-end wrench
•
Spirit-level
•
Aluminum tape (DO NOT use insulating tape)
•
Saw
•
Tin snips
•
Work gloves