operation manual

10
Assembly Instructions
Dear client,
The THOMAS wet & dry vacuum cleaner
will give excellent cleaning results
throughout your home and workshop.
The Wet & Dry models INOX 1420 plus/1520 plus
and INOX 1520 S are delivered with a 20-liter
stainless-steel dirt collecting bin, and enhanced
motor casing with protection against splash water.
Assembly Instructions
A Assembling the chassis
The parts to be assembled are supplied loose
for packing reasons. Open the snap fastener
and lift up the motor head.
Place the container with opening facing
downwards. Insert the steering castors
with bolts in the drill holes marked with the
number 4 and press in the bolts up to the
stop. Make sure that one steering castor
is directly in line under the suction intake
opening.
B Fitting the motor block
Place the motor block onto the collecting bin,
making sure that the operating switch lies
directly in line with the middle of the suction
socket. Lastly, secure the motor block by
means of both snap fasteners.
C Connecting the flexible hose
Connecting the flexible hose. Remove the
hose by turning the hose connecting piece
and withdrawing the hose.
Assemble the accessoires you require.
Connect the main cable.
Operating the appliance
The Appliance is switched on and off by
means of the switch located on the motor
block casing.
The mains supply voltage must correspond to
the voltage given on the rating plate.
D Changing the cartridge filter
(Optional extra, Part no. 787021/421)
Pull out the plug!
Undo the snap fasteners, remove the motor
block from the collecting bin and turn over.
Secure the cartridge filter by the pre-mounted
retaining clips.
Place the new cartridge filter in an upright
position on the motor flange and gently
but firmly slide it into place on the filter
mounting. The pre-mounted retaining clips
automatically snap into place, thus securing
the cartridge filter. Place the motor block
on the collecting bin again and secure by
means of the snap fasteners.
E Inserting the paper filter bag
(when changing the paper filter bag)
Place the filter bag inside the collecting bin,
making sure that the opening located in the
cardboard inlay is placed in line with the
suction socket.
Then press the filter bag evenly
around the sides of the collecting bin.
Thomas paper filter bags are essential
when vacuuming fine dust, e.g. soot, ashes,
sawdust or cement. However, they are also
recommended for normal use, as they not
only improve the retention of dust, but also
make filter changes more hygienic.
Changing the cartridge filter
Gently pull the retaining clips back in the
direction indicated and carefully remove the
cartridge filter in an upright position from the
filter mounting.
+
F