Instructions / Assembly

2. Do not thin.
3. Shake well - intermix all cans (of the same color) to be used to assure
color uniformity. Shake, stir or mix thoroughly before and occasionally
during use.
4. A small trial patch should be tried before application over the entire
surface. Final color appearance differs from initial application.
5. Apply using an exterior paint pad, brush, roller, dipping or compression
driven sprayer.
6. A thin coat should be applied at a rate the wood will absorb. Excess
product allowed to sit on surface will result in a tacky finish and extended
dry time. If over applied, remove excess before it dries by redistributing to
dry areas or wiping off.
7. Use natural breaks (windows, doors) as boundaries to divide large areas
into more manageable work areas.
8. Only one coat of Thompson’s® WaterSeal® Penetrating Timber Oil is
recommended. A second coat may be applied depending on wood porosity
and wood moisture content.
9. Use only with adequate ventilation.
DRYING
• Drying time will vary depending on temperature and humidity.
• Under normal conditions, Thompson’s® WaterSeal® Penetrating Timber
Oil should dry to the touch within 8 hours.
• Wait 24 hours for heavy foot traffic and outdoor furniture placement.
CLEAN UP
Clean brushes and equipment with mineral spirits following manufacturer’s
safety recommendations, then rinse with clean water.
CAUTIONS
DANGER! HARMFUL OR FATAL IF SWALLOWED.
COMBUSTIBLE! VAPOR HARMFUL. IRRITATES EYES, SKIN
AND RESPIRATORY TRACT.
CAUTIONS: CONTAINS AROMATIC HYDROCARBONS. Contents
are COMBUSTIBLE. Keep away from heat and open flame. VAPOR
DANGER: Rags, steel wool, other waste soaked with this
product, and sanding residue may spontaneously catch fire if
improperly discarded. Immediately place rags, steel wool,
other waste soaked with this product, and sanding residue in
a sealed, water-filled, metal container. Dispose of in
accordance with local fire regulations.