Instructions / Assembly

ManualsBrandsThompson's WaterSeal ManualsExterior Stain & Waterproofing1 gal. Mahogany Semi-Transparent Penetrating Timber Exterior (4-Pack )

Timber Oil

BEFORE YOU BEGIN

 For exterior use only.

 Be sure that both surface and air temperatures are above 50°F during

application and remain above 40°F for 48 hours after application. Do not

apply product if rain is forecasted within 24 hours of application.

 Perform the splash test. Sprinkle water on various sections of surface to be

sealed. If water absorbs and darkens color of substrate within five

seconds, surface is porous and considered ready to be treated. If water

Summary of content (4 pages)

PAGE 1
Timber Oil BEFORE YOU BEGIN    For exterior use only. Be sure that both surface and air temperatures are above 50°F during application and remain above 40°F for 48 hours after application. Do not apply product if rain is forecasted within 24 hours of application. Perform the splash test. Sprinkle water on various sections of surface to be sealed. If water absorbs and darkens color of substrate within five seconds, surface is porous and considered ready to be treated.
PAGE 2
    beads up or otherwise sits on top of surface, then surface does not need protection at this time. Cover plants and shrubs. Move all objects that could come in contact with overspray. Wet overspray of product can be removed by flushing immediately with water. Dried overspray can be removed with paint thinner or mineral spirits, following manufacturer’s safety recommendations. Do not use in below grade application where water pressure is a problem, or on painted or recently stained surfaces.
PAGE 3
2. Do not thin. 3. Shake well - intermix all cans (of the same color) to be used to assure color uniformity. Shake, stir or mix thoroughly before and occasionally during use. 4. A small trial patch should be tried before application over the entire surface. Final color appearance differs from initial application. 5. Apply using an exterior paint pad, brush, roller, dipping or compression driven sprayer. 6. A thin coat should be applied at a rate the wood will absorb.
PAGE 4
HARMFUL. Use only with adequate ventilation. To avoid overexposure, open windows and doors or use other means to ensure fresh air entry during application and drying. If you experience eye watering, headaches, or dizziness, increase fresh air, or wear respiratory protection (NIOSH approved) or leave the area. Avoid contact with eyes and skin. Wash hands after using. Keep container closed when not in use. Do not transfer contents to other containers for storage.