User's Manual

14
4. Place the handset in the base cradle. The charge/in use
indicator turns on, verifying the battery is charging.
5. Allow the phone to charge for 14 hours prior to first use. If
you don’t properly charge the phone, battery performance is
compromised.
CAUTION: To reduce risk of personal injury, fire, or
damage use only the 5-2757 power adaptor listed in
the user’s guide. This power adaptor is intended to
be correctly orientated in a vertical or floor mount
position.
Wall Mounting
1. Plug the AC power adaptor into the electrical outlet and the DC
connector into the jack on the back of the base.
2. Plug one end of the straight telephone line cord into the jack on
the bottom of the base.
3. Close the kick-stands on the bottom of the base unit if you’ve
opened them before.
4. Feed the line cord through the groove and plug the end into the
modular telephone jack.
5. Slip the mounting holes (on the bottom of the base) over the
wall plate posts and firmly slide the unit down into place.
Answering System Setup
This section shows you how to set up your answering system to
receive incoming calls. Before you begin the set up process, you
must turn on the answering system.
• Press the
ANS ON/OFF button to turn the answering system
on and off. The Message Indicator lights when the answering
system is on. The indicator blinks when you have new
messages.
NOTE: The answering system displays “- -” when it is off.