User's Manual

30
NOTE: Handsets can be on cradle or off cradle for room monitoring to
work.
NOTE: While in room monitoring mode, the listening unit will emit an
alert tone approximately every 4 seconds if there is an incoming call.
You may press the LINE 1 or LINE 2 button to quit room monitor and
answer the call.
NOTE: Press the CANCEL Soft Key or the END/CANCEL button to exit
room monitor mode.
Call Transfer
During an external call, you may transfer the external call from base to handset(s)
or vice versa.
NOTE: To cancel the call transfer, you may press END/CANCEL button or
int button on base.
1. Press the int button to put the line on hold. LX ON HOLD shows in the display, where X
is the Line number.
2. Use the 5 or 6 buttons to select the desired handset or base. Press the SELECT Soft
Key Left (SKL) to confirm.
NOTE: If you only have one handset registered in the system, it is
paged automatically.
3. Press the END/CANCEL button to transfer the call. TRANSFERRING FROM XXXX (where
XXXX is the name of the transferring unit) shows in the receiving unit's display.
4. Press the OK Soft Key Left (SKL) on the receiving unit to answer the call.
NOTE: If there is no answer within 2 minutes after transferring the call,
then both units receive a call back notification. If neither unit answers
within 30 seconds, then the external call will be automatically dropped.
Push to Talk
This feature allows you to directly talk to another registered handsets or base by pressing
the PUSH TO TALK button on either handset or base respectively.
1. Make sure your phone is OFF (not in TALK mode).
2. Press the PUSH TO TALK button on base or handset.
3. A list of registered handsets and base shows on the display.
4. Use the 5 or 6 button to desired handset or base. The default setting at base is
HANDSET 1 and the default setting at handset is BASE.
5. Press the SELECT Soft Key Left (SKL) to save your selection.
6. Press and hold the PUSH TO TALK button to connect with the desired handset or base.
Is CANCEL
Soft Key Left
or Right?