User's Manual

PAGING

HANDSET 2

EXIT

PAGING FROM

HANDSET 1

OK EXIT

Intercom Operation

A two-way intercom is possible between the base and cordless handset(s) without

tying up the telephone line and since the telephone line is not used, you can still receive

incoming calls.

Making an Intercom Call

1. Make sure the phone is OFF (not in TALK mode).

2. Press the int button.

3. Use the

5 or 6

buttons to select the desired handset or base.

NOTE: If you only have one handset registered in the system, it is

paged automatically.

4. Press the SELECT Soft Key Left (SKL).

5. The receiving handset or base is paged, a tone is sounded and the following

information shows in the display:

Is CANCEL

Soft Key Left

or Right?

Originating Handset/Base Receiving Handset/Base

When the OK Soft Key Left (SKL) or int button on the receiving handset or base is pressed,

the page is answered. If the page is not answered after two minutes, NO ANSWER shows

in the display of the originating handset or base and the page is cancelled. The unit

returns to standby mode.

NOTE: If a personalized name is assigned to the handset during

registration, then that name is displayed instead of handset number.

NOTE: To cancel the page, press the EXIT Soft Key Right (SKR) or int key

on the originating unit.

Receiving an Intercom Call

When you receive an intercom call, the handset or base beeps. To answer the intercom

call, press the OK Soft Key Left (SKL), LINE 1 or LINE 2 button or the int button.