Operation Manual

4
Installing the telephone base
The telephone base should be placed at least 1 meter away from other electrical appliances in order to avoid
interference. The handset exchanges radio signals with the telephone base. The strength of these signals
depends on the position of the base. You can obtain a stronger signal by placing the base higher.
Operating range of the handset
The operating range of your telephone is 300 meters outdoors without obstructions between the telephone
base and handset. Obstructions reduce the operating range. When the telephone base is located indoors, while
the handset is indoors or outdoors, the operating range is reduced to 50 meters. Thick concrete walls reduce
the operating range significantly.
Signal strength
When the handset is within the operating range of the telephone base, appears on the screen. If the
handset is out of range of range, the symbol flashes on the display. Get closer to the telephone base to
turn off this indicator.
Installing and charging the batteries
1. Insert the plug of the supplied adapter to the back of the telephone base and the other end into an
electrical outlet.
2. Plug the telephone line cord to the back of the telephone base and the other end into a telephone wall
jack.
3. Insert the rechargeable Ni-MH batteries supplied into the handset by following the correct polarity as
indicated. Close the battery compartment.
4. Place the handset on the telephone base and let the batteries charge for 24 hours before using it for the
first time.
Low battery warning
When the batteries are very low, flashes on the handset screen to prompt you to recharge the batteries.
Battery performance
When fully charged, the batteries offer approximately 9 hours of talk time and 100 hours of standby time
under ideal conditions. Please note that a new battery reaches its full capacity after several days of normal use.
The battery capacity decreases over time, reducing the talk time and standby time. Replace the batteries if
necessary.
The batteries and the handset will become hot during charging. This is normal.
Tip
When you are not using your handset, place it on the charger so that you can always have fully charged
batteries.
Telephone Jack
Adapter Jack