Operation Manual

21
Trouble shooting
 No signal icon displayed on the display
 The handset is out of range. Move it closer to the base.
 No dialing tone
 Check your phone connections.
 The handset is out of range. Move it closer to the base.
 No docking tone
 The handset is not placed properly on the base / charger.
 The charging contacts are dirty. Disconnect the power adaptor first and clean the contact with proper damp
cloth.
 The handset on the charger does not charge
 Make sure the batteries are inserted correctly.
 Make sure the handset is placed properly on the base / charger
 The charging contacts are dirty. Disconnect the power adaptor first and clean the contact with proper damp
cloth.
 Batteries are defective. Purchase new ones for replacement.
 No display
 Make sure the batteries are charged.
 Make sure there is power input and the phone is connected.
 The handset has no ring
 Long press # button to turn on the ringer.
 Keypad is no use
 Check if keypad is locked. Long press * button to unlock the keypad.
 The volume is too low when taking a call
 Press ▲ button to increase the volume.
 Remote Control failed
 Check if the caller press # button and input TAM PIN code (default as 0000) after hearing outgoing message.
 PIN code is lost
 You can restore the PIN code to the default value (0000) via Menu>Advanced set> Reset. The PIN code for
remote access can be restored in the same way.
 Most of the functions failed
 If the battery icon is flashing, charge the batteries.
 Remove the battery, unplug the lines and reinstall after 10 minutes.
Note:
If none of the above suggestions solves your problems, try unplugging the telephone base from the mains and
removing the batteries from all handsets. Wait 15 minutes and then reconnect everything.