Operation Manual

P8
MAIN MENU
5.1.3 Delete all Favourites and Groups
Use this menu to delete all favourite channels. Select Delete All Favourites with p/q and
press OK. Use
t/u to select Yes in the confirmation window and press OK to delete or select
No to cancel.
5.1.4 Delete all
Use this option to delete all channels. Select Delete All with p/q and press OK, then enter
the Password (default:0000). In the confirmation window select Yes with
t/u and press OK to
delete or select No to cancel.
5.1.5 Group Rename
In this menu you can change the name of favourite groups. Use p/q to select Group
Rename and press OK to enter.
1. Select a group with
p/q and press OK.
2. Use
p/qt/u to navigate the on screen keyboard. Highlighted characters can be
inserted by pressing OK. After entering the desired group name, highlight OK at the
keyboard and press OK on the remote control to confirm.
3. Press EXIT/SORTIE to leave without saving your changes.
5.2 Installation
5.2.1 Auto Scan
1. Use p/q to select Installation and press OK to enter menu.
2. Use
p/q to select Auto Scan and press OK to enter the menu.
3. Change the Scan Mode with
t/u. Options are: Free for searching Free To Air channels
only or All for all channel search.
4. Use
p/q to highlight Action and select Reinstall to create a new channel list or Update to
update the current channel list with newly found channels.
5. Use
p/q to highlight Search and press OK to start auto scan.
5.2.2 Channel Scan
1. Use p/q to select Installation and press OK to enter the menu.
2. Select Channel Scan with
p/q and press OK to enter.
3. Use
t/u to select the desired Scan Modes – By Channel or By Frequency.
4. When By Channel is selected, use the cursor buttons to select Scan Band and Channel
No. When By Frequency is selected, use the cursor buttons to select Frequency and
Bandwidth. Set Network Search to ON or OFF, highlight Search and press OK to start
scanning. Found channels will be stored and the receiver will switch to the first channel in
the list.
5.2.3 Antenna Setting
1. Press MENU to enter main menu.
2. Use
p/q to select Installation and press OK to enter the menu.
3. Select Antenna setting with
p/q and press OK to enter.
4. Use
t/u to change the setting. If On is selected, the receiver will provide 5V antenna
power on the antenna input (for active antennas).
5. Press EXIT/SORTIE to exit.