Operation Manual

P10
MAIN MENU
5.3.5 Timer Setting
Use this menu to setup programme timers or sleep timers.
Programme timer
Timer Number: You can set up to 8 timers
Timer Mode: Off/Once/Daily/Weekly/Monthly
Timer Service: TV Service/Radio Service
Wake-up Channel: You can select any channel as wake-up channel.
Month/Date/Day: Use
p/q to select the start month, date and day.
Time: Press OK to input the time with the numeric buttons.
When you leave the programme timer, a saving window appears.
Use
t/u to select Yes in the confirmation window and press OK
to save your settings or No to cancel.
Duration: Press OK to input the timer duration with the numeric buttons.
Auto Record: When set to On, the receiver will record the timed event on the
connected USB device. Select Off to disable automatic recording of
the event.
Sleep Timer
You can set the receiver to power OFF in 10 min, 30 min, 60 min, 90 min and 120 min
automatically.
5.3.6 OSD Setting
This menu allows you to change settings for: Subtitle Display, OSD and Transparency. You can
also restore the default OSD settings here.
Subtitle Display: To set the subtitle to Standard or OFF.
OSD Transparency: To set the OSD transparency from Off ~ 50%.
OSD Timeout: To define how long the information banner is to be shown (5S~10S)
Load Default OSD Setting: To clear all OSD settings and reset to default value.
5.3.7 Parental Lock
This menu allows you to protect the installation menu or channels with a password. And
you can change the Password here. When entering the menu you will be asked to input the
password (default: 0000).
Menu Lock: Locks the installation menu. You can set menu lock to ON/OFF.
Channel Lock: Off/Manual/Age: 4 - Age: 18
New Password: Input your new password here to change the password.
Confirm Password: Input your new password again to confirm the new password.
5.3.8 Auto Standby
This option allows you to enable or disable Auto Standby. The default setting for Auto Standby
is ON. The receiver will switch to standby automatically when it doesn’t receive commands from
the remote control for three hours. To avoid the automatic switch off, set Auto Standby to OFF.
5.4 Tools
Press MENU to enter Main Menu. Select Tools with p/q and press OK to enter.
1. Use
p/q to highlight the desired menu and press OK to enter.
2. Press EXIT/SORTIE to leave.