Operation Manual

6
Figure 1:
Open the rechargeable battery compartment on the right side (R) of headphone receiver,
and insert two AAA type rechargeable batteries as enclosed in the packaging of the
product, making sure their positive and negative (+ and -) poles are correctly aligned.
Figure 2:
Close the rechargeable battery compartment.
Figure 3:
Insert the plug of the AC/DC power supply adapter into the socket marked DC IN at
the rear of the charging station and then connect the adapter to a wall socket with
230
V and 50 Hz.
Figure 4:
The red signal/power indicator turns on when you have connected the charging stati-
on to an audio source that is switched on.
Figure 5:
Place the headphones on the charging station, ensuring that the charger contacts on
the headphones are touching the contacts on the station (headphones locked back-
wards into place). Now check that the green charging control indicator on the station
is illuminated. Allow the headphones to charge for 24 hours. Subsequent charging
cycles then last approx. 10 hours.
Figure 6:
Connect the audio input to the headphone jack of an audio device (e.g. amplier)
using the 3.5 mm jack cable. To connect the (R) and (L) audio outputs of your stereo
or TV, use the included jack/RCA adapter. Switch on the device and set the volume to
about one quarter of the maximum level.
Figure 7:
Switch on the headphones and make sure the red signal/power LED is on: this
conrms that the rechargeable batteries are charged. Turn the dial control for the
volume to a medium volume.
Figure 8:
Turn the volume down on the headphones before putting them on your head; once
you are wearing them, adjust the volume to suit.
Figure 9:
Switch the headphones off after use and place them back on the charging station, so
that the rechargeable batteries can be charged again.
Operating Instruction