Manual Spec Sheet
Table Of Contents
- Warnings
- Welcome
- Before You Start
- Safety and Warnings
- Safety Symbols
- Electrical Shock Hazard
- Tipping Hazard
- Explosion Hazard
- Fire Hazard
- Poisoning Hazard
- Hot Surface Hazard
- Other Safety Tips
- Dual Range Overview
- 48-inch dual range sample
- Cooktop Equipment
- Installation Instructions
- On the next figure, item A is:
- Positioning of Range
- Dimensions and Clearances
- Top Hood and Cabinet Specifications
- Important Notes to the Installer
- Important Note to the Consumer
- Important Safety Instructions to the Installer
- Model and Serial Number Location
- Electrical Installation
- Power Supply Cord Kit
- Access to Terminal Block
- Electrical Shock Hazard
- Electrical Connection
- Electric Power Supply Requirements
- Electrical Grounding Instructions
- Gas Supply Requirement
- Connect Range to Gas Supply
- After installation:
- First Use
- Before you start
- Conditioning the oven
- Positioning the shelves
- Cooktop Safety Guidelines
- Surface Burner Ignition
- Simmer and Boil
- Flame Size
- Power Failure
- Cooktop
- Burner Grates
- Oven Burner Use
- Broil Burner Use
- Oven Cooking Safety Guidelines
- Oven Function
- Natural Airflow Bake
- Convection Bake
- Convection Roast
- Convection Defrost
- Defrosting
- Convection Dehydration
- Broiler Operation
- Preheating
- To Broil
- Setting Broil
- Broiling guidelines
- For the models with Griddle
- Before Using the Griddle
- Use of the griddle
- Cleaning Instructions
- Do’s
- Don’ts
- Cleaning Burner Caps and Brass Flame Spreaders
- Cleaning the Control Panel, Door Handle, Control H
- Cleaning Side Racks
- Cleaning Oven Shelves
- Cleaning Broiling Pan and Grid
- Cleaning Bake and Broil Burners
- Cleaning Porcelain Surfaces
- Cleaning Oven Window
- Cleaning Oven Door Gasket
- Cleaning Stainless Steel Surfaces
- Removing and Replacing Oven Door
- Replacing Burner Parts
- Removing Oven Door
- Replacing Oven Door
- Replacing Oven Light Bulb
- Procedure for Checking the Dual Burner Clicking Pr
- Step 1
- Step 2
- Step 3
- Step 4
- Troubleshooting Guide
- Cooktop
- Oven
- Warranty and Service
Installation Instructions
28
Electrical Connection
Four Conductor Wire Connection to Range
1. Remove the screws at the lower end of the rear access cover and take it down to expose range
terminal connection block.
2. Remove the screws to lose the cable clamp and pass through the four-conductor wire from the
bottom of the range.
3. Loose the screws on the terminal block and connect the wire to terminals, after then, tighten
the screws of cable clamp and terminal block, please make sure that match the wire and
terminals by color.
4. Put back the terminal cover and tighten the screws.