User manual

Further Tonearm Adjustments

The tonearm headshell allows an overhang adjustment

of ± 2,5 mm to be made. To adjust overhang, loosen the

screw holding the headshell and move the headshell as

required. ➔ Fig. 13

A screw at the rear of the tonearm allows a further over-

hang adjustment of ±3 mm as well as an azimuth ad-

justment of ±5°. The screw is recessed into the top of

the bearing housing and can be loosened with a 2-mm

hex key. ➔ Fig. 14

The vertical tracking angle (VTA) can be adjusted by

raising or lowering the tonearm. ➔ Page 34

Take care not to over-tighten the screws after making

adjustments.

Fig. 13

Fig. 14