User manual

Further Tonearm Adjustments

The vertical tracking angle (VTA) can be adjusted by

raising or lowering the entire tonearm. Loosen the

lock nut on the underside of the turntable with a 22-mm

jaw spanner; then turn the adjustment ring above the

base to raise or lower the tonearm as required. ➔ Fig. 15

If the VTA is changed, the tonearm lift will need to be

to be readjusted. Loosen the locking screw on the to-

nearm lift with a 1.5-mm hex key and carefully raise or

lower the entire lift. ➔ Fig. 16

The tonearm tube should be parallel to the platter

surface. Small adjustments of the VTA or the tonearm

lift height can have a large effect. After making any

changes, you should therefore always check whether

there is enough clearance (at least 1 mm) between

the cartridge and the record (when the lift is engaged)

and between the tonearm lift pad and the tonearm

tube (when the lift is disengaged).

Fig. 15

Fig. 16