Installation & Assembly

REMOTE CONTROL INSTALLATION INSTRUCTIONS

1. Wire the receiver and fan.

Make the following wire connections according to

the diagram and the following steps:

• Connect the Green wires from the downrod and

the mounting bracket to the Bare/Green (ground)

supply wire.

• Connect the Blue from the receiver to the Blue

fan wire.

• Connect the White wire (white label) from the

receiver to the White fan wire.

• Connect the Black wire from the receiver to the

Black fan wire.

• Connect the Black wire (red label) from the

receiver to the Black (hot/power) supply wire.

• Connect White wire (red label) from the receiver

to the White (neutral) supply wire.

Black (hot/power)

White (neutral)

Bare/Green

(ground)

White

Black

White

Blue

White

Green

Receiver

Front Back

Battery

LED Indicator

Fan Power

2. Install the battery.

Remove the battery cover from the back of the remote. Insert the battery

into the remote; ensure polarity of battery matches the polarity indicated

in the battery compartment -- positive (+) to positive (+) and negative

(-) to negative (-). Replace the battery cover and press the fan power

button on the remote to ensure the LED indicator illuminates and the

remote turns on the fan.

Important: Once the remote is installed, it is best to avoid using the wall

switch to turn the fan on. The wall switch can send a small power surge

to the fan causing the fan to become unsynced.

WARNING: To reduce the risk of re or electric shock, do NOT use a

full-range dimmer to control fan speed.