Instructions / Assembly

TRAMPOLINE & ENCLOSURE ASSEMBLY
Refer to PARTS LIST for identification of parts.
!
WARNING:
CHOKING HAZARD - Small Parts
!
WARNING:
ADULT ASSEMBLY REQUIRED
Contains small parts, sharp points and sharp edges.
13.
1
14. 15.
16. 17. 18.
1
19. 20. 21.
10. 11. 12.
Insert one Top Enclosure Pole(#I) through
the tube sleeve on Safety Net(#C).
Repeat the step until all Top Enclosure
Poles(#I) are connected to each other and
the vertical Enclosure Pole(#H).
Attach the Lower Mesh(#D) to the outside
of the Leg Tubes(#J). Please note the side
with grommets is the bottom side.
Align the grommet on the bottom of the
Lower Mesh skirt with the hole near the
base of the Leg Tubes(#J) and secure with
6 Screws(#E).
Now the trampoline base is completed.
Insert the Enclosure Pole(#H) into the
Lower Rails(#G).
Continue to insert all 6 Enclosure
Poles(#H) into the frame.
Connect the Top Enclosure Pole(#I) to the
vertical Enclosure Poles(#H) with Plastic
Connector(#L).
7
Attach the plastic hooks at the bottom of
the Safety Net(#C) to the triangle ring sewn
on the Jump Mat(#B).
Assembly completed.
①
②
③
④
⑤
⑥
Put a second Top Enclosure Pole(#I)
through the tube sleeve on Safety
Net(#C), and connect it to the vertical pole
with Plastic Connector(#L).
Tie the bungee on the Lower Mesh(#D) to
the bottom of the pole to secure its place.