Installation Sheet
RDQCI5214 Rev. 0 Page 9 Cered 06/01/2016
RDQCI5214 Rev. 0
Page 8 of 8 Certified 06/20/16
11 Place the sweep onto the bottom of the door.
Stand inside the shower, close the door and mark the
deflector part of the sweep at the inside edge of the
strike jamb.
Open the door and remove the sweep. Notch the
inside portion of the sweep so the door glass will
close tightly to the strike jamb vinyl.
Place the sweep back on the door and check for
clearance.
ENOCILIS
WALL
JAMB
STRIKE
JAMB
CURB
12 Carefully silicone the seam between the wall
and the wall jamb as well as the curb and threshold
on the inside of the shower.
NOTE: Silicone on the exterior seam is optional.
DO NOT USE the shower until the silicone is
completely cured. Check the tube of silicone
for the manufacturer recommended cure time.
(typically 24 - 48 hours)