Installation Guide
Page 17
Installing CableRail by Feeney
®
for AZEK Rail
ATTACH QUICK-CONNECT AND QUICK-CONNECT SWIVEL FITTINGS
• Screw on Quick-Connect fi ttings snuggly against Post Sleeve onto one side
of the railing and lock nuts onto hanger bolts on the other side.
4
INSERT AND THREAD CABLE
5
CUT CABLE TO LENGTH
6
• Screw on Quick-Connect Swivel fi tting onto the Hanger Bolt with the lock
nut already installed.
One side of the railing will be
only Quick-Connect fi ttings, the
other side will be Quick Connect
swivel fi ttings and lock nuts.
• When all of the hardware is in place, insert one end of the
Cable into the Quick-Connect fi tting.
• Feed the Cable through the Intermediate Baluster (or
through posts) with a lacing needle.
CUT CABLE TO LENGTH
Feed the Cable through the Intermediate Baluster (or
through posts) with a lacing needle.
Lacing Needle
Unscrew the Quick-Connect
swivel fi tting from the post to
measure length of cable
a
Trim Cable at the fi rst
cut line on Quick-
Connect Swivel Fittings
Insert Cable into
Quick-Connect
swivel fi ttings
b
c