Installation Guide

Page 4
Installing RadianceRail Express
®
System
ASSEMBLE
BRACKETS ONTO
TOP AND BOTTOM
RAILS
3
4
ATTACH FOOT BLOCKS
ON BOTTOM RAIL
1/3
1/3
1/3
1/2
1/2
Foot Blocks
8’ Section
Bottom Rail
3” Screws
6’ Section
For sections up to 6’: Place one Foot Block in the center of the rail
For sections 6’ to 8’: Space two Foot Blocks approximately at 1/3 intervals on the rail
Straight SectionAngled Section
Bracket set flush
to rail face unless
using Gasket. Cut Rails
1/8” shorter if using
Gaskets.
Determine angle
and snap off
corresponding
wing
Only need to pre-drill Foot Block
when doesn’t fall on routed hole.
Pre-drill 9/64”
#10 x 1 5/8”
Coated Screws
Bore 1/2”
Hole
Drill 3/16”
Hole
2 1/2”
Foot Block Preparation
Gaskets are optional and can be used to
provide a clean edge on cut rails.