Installation Guide

Page 3
Installing RadianceRail
®
with Balusters
1/3
1/3
1/3
1/2
1/2
1 2
3
• Trim Post Sleeves
to desired length.
39” above deck surface is
optimal for 36” railing heights.
• Slide Post Sleeve and Post
Skirt over post (do not
force).
• Ensure post are
square and plumb.
INSTALL POST
SLEEVES
INSTALL LOWER
SUPPORT BLOCK
• Position template at
bottom of Post Sleeve
above Post Skirt.
If you do not have a the template, position
the top of the Support Block 4” above the
deck and 2-1/2” above the post skirt.
CUT AND ASSEMBLE
BOTTOM SUPPORT
RAIL
• Cut the Bottom
Support Rail to
length.
For sections up to 6’: Place one Foot Block in the center of the rail
For sections 6’ to 8’: Space two Foot Blocks approximately at 1/3 intervals on the rail
For sections 8’ to 10’: Space three Foot Blocks approximately at 1/4 intervals on the rail
45°
Straight Section
Angled Section
Center screw aligned to
rail centerline
Foot blocks
8’ Section
6’ Section
Center screw
aligned to rail
centerline
Bracket set
flush to rail
face
Bracket set
flush to rail
face
For angled rail installations, align
angled face of Support Block
parallel to rail section.
Optimal 39”
4”
2.5”
Template
Support
Block
Post Skirt
Pre-Drill 7/64”
#8 x 3” Coated
Screws
Pre-Drill 7/64” for Brackets
#8 x 3/4” Coated Screws
Pre-Drill 7/64”
#8 x 3” Coated Screws