Installation Guide

Page 9
4
a.
b.
c.
• Place the next board into position against the fasteners.
Slightly raise the outer edge of the board being installed and
slide it onto the fastener until the board contacts the spacer
tab. When properly installed the inserted board should be
in contact with the bent-forward spacer tab at the left end
of the clip. To achieve this use a scrap piece of decking at
least 24” in length and use it as a tamping block to drive the
board further onto the clip and the screw will fully engage the
board to the spacer tab if not already in contact. Do not use a
hammer or damage to the edge of the board will occur.
• The last board will need to have the outside edge attached
using the method described in Step #1. It may be necessary
to rip the last board to fit.
COMPLETE INSTALLATION
5
HOW TO INSTALL AT BUTT JOINTS
(UNLESS USING TIMBERTECH
®
L-BRACKET)
Offset 1/4”
From Center
3
• Install provided screw at 45° angle through
the fastener and into the joist while applying
pressure on the fastener.
• Install one fastener and screw at each joist.
• Make sure fastener is in full contact with edge
of board and the screw is holding the fastener
down tight to the deck board.
INSTALL CONCEALoc
®
FASTENERS
CONCEALoc
®
Hidden Fastener
Joists at butt joints must be
doubled up for proper
fastener attachment.
• Install fasteners as detailed below.
Note that the two clips on the right
are shifted approximately 1/4” to
the right of center on the joists. If
this is not done the spacer tab may
fall within the gap of the butt joist.