Use and Care Manual

Remember to keep the knees bent and the back straight.
Battery Replacement
To replace the batteries reverse the sequence above Important:
Remember to keep the knees bent and the back straight.
When reassembling the scooter, remember to insert the locking pin,
because failure to do so may result in the batteries disengaging during use.
Ensure the battery wells are free from dirt and grit - this will affect the
performance of the battery contacts.
Off-Board Battery Charger
Your scooter is supplied with an off-board charging facility (Photo 10.5).
Please note that only chargers with a capacity of minimum 3.0 Amps and
maximum of 6.0 Amps supplied by your local authorized dealer should be
used.
1. Switch your scooter off at the key switch(Photo 7.5).
2. Swivel the charge connector cover located on the batter pack and
connect the charger (Photo 10.6).
3. Ensure that the charger plug is dry and intact before connecting it to the
mains and switching it on.
4. A reset button is located on the battery.
Please check that the button is pressed in (Photo 10.7).
P10.4 P10.5 P10.6
P10.7
Note:
The charger is capable of charging from 240V to 100V, and 2Amp, off-
board charger has 3 possible indications:
1. RED = Power is on.
2. YELLOW = Charging.
3. GREEN = fully charged.
Ensure the scooter is switched off before commencing the charging
process. After charging, always swivels the charging socket cover back
into place. This helps prevent water getting into the socket.(Photo 10.6)
Please note that the scooter has a safety circuit to prevent it from being
15