Use and Care Manual

Transportation
Your scooter may be disassembled quickly and simply for transportation.
1. Switch off the scooter, make sure the motor is engaged.
2, Remove the basket.
3. Remove the seat, leaving the seat stem in position.
4. Place the basket on the floor mat appropriately(photo 11-1).
5. Lower the tiller, using the folding knob, to its lowest setting locking in the
basket. Make sure that there is at least 30mm between Tiller and battery
pack(photo 11-5).
6. Using the lifting handles provided carefully lift the scooter safely and
securely into the luggage compartment of the vehicle(photo 11-6,7).
TIP:
1. Please put all the parts after disassembling into the original carton
from us to insure the safe transportation.
2. To reverse the above steps to reassemble your scooter.
Important:
When reassembling the scooter, remember to insert the battery locking pin,
because failure to do so may result in the batteries disengaging during use.
Always secure your scooter parts before transportation. Remember to
engage the drive unit by pushing the freewheel lever forwards to stop the
scooter from moving. Don’t sit on the scooter during transportation.
P11-5 P11-6
P11-7
Packaging and transportation environment conditions
The mobility scooters can be transported by common transportation
vehicles, but you need to prevent them from strong impact, vibrating or any
snow or rain. This is clarified in the order contract.
The packaged scooters should be put into an environment between -
20℃ ～ 45℃temperature, and humidity less than 93%, no congeal or
corrosive air with good ventilation.
18