Use and Care Manual

checking that it is LOCKED into position. Attempting unsafe transfers can
result in bodily injury and/or damage.
DO NOT drive your scooter if the seat is not LOCKED in the FORWARD
position. The seat must be secured in the FORWARD facing position
BEFORE and DURING operation of the scooter. Attempting to operate the
scooter with the seat not secured in the front facing position, could result
in damage and/or bodily injury.
DO NOT operate the scooter without ensuring that the Tiller is properly
adjusted and secured. After making any adjustment to the Tiller position
you must check that the Tiller is locked and secured into position BEFORE
driving. To check, gently push and pull the Tiller to make sure it is secured.
An unsecured Tiller could result in damage and/or bodily injury.
DO NOT attempt to climb, ascend, or descend ramps greater than 10
degrees, or transverse slopes with a gradient greater than 10 degrees. DO
NOT attempt to reverse down slopes in excess of 8 degrees.
When negotiating ramps or inclines, if the throttle lever is released a roll
back will occur.
In FORWARD or REVERSE motion the scooter will ROLLBACK
approximately 30cms. (1ft), before the brake engages.
Check that all electrical connections are secure before using your scooter.
DO NOT under any circumstances, disconnect, cut, extend or otherwise
modify ANY of the wiring harnesses installed within or connected to your
mobility scooter.
DO NOT under any circumstances, disconnect, cut, extend or otherwise
modify ANY of the wiring harnesses installed within or connected to your
mobility scooter battery charger.
It is important that your mobility scooter battery charger is connected to a
properly installed electrical socket with an earthed outlet.
Failure to comply with the above requirements could result in a
possible SHOCK HAZARD.
DO NOT use any batteries that are not DEEP CYCLE GEL, AGM or
SEALED LEAD-ACID type. Other types of batteries are NOT SUITABLE.
Please read battery/battery charger information before installation.
This scooter has been tested to ISO 7176 Part 9 “Climatic Tests for
28