Use and Care Manual

Guidance and manufacturer’s Declaration–electromagnetic emission
（SW-1000Sscooter）is intended for use in the
electromagnetic environment specified below. The customer or
the user of the （SW-1000Sscooter） should assure that it is
used in such an environment.
IEC 60601
Complia
electromagnetic
Immunity test
nce
environment-guidanc
test level
level
e
Floors should be wood,
Electrostatic
concrete or ceramic
±6 kV
tile. If floors are
discharge
±6 kV contact
contact
covered with synthetic
（ESD）
±8 kV air
±8 kV air
material, the relative
IEC 61000S-4-2
humidity should be at
least 30%.
±2kV for
power
Electrical fast
±2kV for power
supply
Mains power quality
supply lines
lines
should be that of a
transient/ burst
±1kV for input/
±1kV for
typical commercial or
IEC 61000S-4-4
output lines
input/
hospital environment.
output
lines
±1 kV
±1 kV
differenti
Mains power quality
differential
Surge
al mode
should be that of a
mode
IEC 61000S-4-5
±2 kV
typical commercial or
±2 kV common
common
hospital environment.
mode
mode
33